BOP HIPWR 111315 3-31programmed waveform. The BOP will complete the waveform cycle and leave the output at thelast point of the waveform. This is chosen using the display menu see Table 3-3.To change the Waveform Stop setting, press # from the power-up screen (Figure 3-3), High-light Waveform Stop, press !, highlight Standby, Last Level or Current Lvl, then $ to save.Press $ exit and save for power-up or % to apply the changes (without saving for power-up)and exit.While the waveform is executing, the display shows a graphic of the programmed waveform(repeating segments only) below the message Waveform Executing.Be sure that output power is OFF (Standby indicator lit) while connect-ing monitoring device. Be sure that connections are secure and thatterminals are not inadvertently shorted.It is recommended that an oscilloscope be used to view the actual output. Connect the oscillo-scope across OUT S and COM S terminals of the rear panel terminal block to monitor the outputat the load, or between OUT MON and COM MON to monitor the BOP output at the BOP (seeFigure 2-1).3.3.9.7 MODIFYING PREVIOUSLY STORED WAVEFORMSTo edit a previously stored waveform, first observe the precautions of PAR. 3.3.9.1, then viewthe waveform and highlight the segment to edit as specified in PAR. 3.3.9.4. (The operatingmode can not be edited; to change from a voltage waveform to a current waveform, refer toPAR. 3.3.9.8 to start a new waveform.)Use Y or U or ADJUST to highlight the segment, then press ! to edit,When editing a segment, a submenu showing the parameters for that segment will open (seeTable 3-11). Use Y or U or the encoder to highlight the parameter, then press ! to edit,change the parameter, then press $ to save or % to abort. Then press $ to save for powerp or % to abort and exit without saving the segment parameters that were edited.To delete a segment, highlight the segment at the Waveform Settings screen (Figure 3-10), thepress #, to permanently erase the segment. This change is saved immediately and can not beundone.To add a segment, at the Waveform Settings screen (Figure 3-10) highlight the segment follow-ing the one to be added (e.g., if there are three existing segments (1, 2, 3), to add a segmentbetween 2 and 3, highlight 3. To add a segment following 3, highlight End of Segments. Afterhighlighting the segment, press @ to insert a new segment. The parameters applicable to thewaveform type selected (see Table 3-11 for details) can then be modified as desired.3.3.9.8 CREATING A NEW WAVEFORM1. After observing the precautions of PAR. 3.3.9.1, press @ from the power-up screen to enterthe Saved Waveforms screen (Figure 3-9), highlight one of the waveforms designatedEmpty, then press @. The Waveform Settings screen (Figure 3-10) opens.WARNING
