BOP HIPWR 111315 3-91. Enter the first character of the password using the keypad or ADJUST control (see PAR.3.2.4.1 for entry of alphanumeric characters). (To change the password, refer to PAR.3.2.4.2.)2. Press T to move to the next character and repeat step 1 for the next character of the pass-word.3. Repeat steps 1 and 2 until the correct password is displayed, then press ! to verify. Theprotected setting or menu will now be accessibleNOTE: If the password is incorrect, the message Password incorrect is displayed at thebottom of the screen. Press CLEAR and proceed to step 1 above.FIGURE 3-5. PASSWORD PROTECTION MENU, FACTORY DEFAULTS3.2.5 OPERATOR CONVENIENCE FUNCTIONS (DISPLAY MENU)From the power-up screen (Figure 3-3), pressing # opens the operator convenience functionsmenu (see Table 3-3). The functions listed can be modified using the techniques described inPAR.3.2.4). This function is always available, whether in Local, Remote or Local/Lockout mode.NOTE: If $ is not available when the operator convenience menu is open, these functions(see PAR. 3.2.5.1 to 3.2.5.4) can not be saved for power-up. To save for power-up it isfirst necessary to change SAVE DISPLAY CHG at the password setup from DISABLE(default) to ENABLE (see PAR. 3.2.4.2 and Figure 3-5). After saving the changes forpower-up, SAVE DISPLAY CHG at the password setup can be set to DISABLE to pre-vent future changes if desired.3.2.5.1 ADJUSTING LCD BRIGHTNESS, CONTRAST AND BACKGROUNDFrom the power-up screen, (Figure 3-3), press # twice to initiate contrast adjustment. Thecontrast gradually alternates between light and dark. When the contrast is acceptable, press #to apply the change and exit contrast adjust. Use the T and R keys for fine adjustment of con-trast. Contrast can also be adjusted from the power-up screen by pressing # once, then press-ing T and R as needed for fine adjustment.VOLTAGESOURCEVOLTAGE CURRENT0.0000 0.0000Admin 2Admin 2
