3-26 BOP HIPWR 111315channel is current, the protection settings are determined by pin 6 (negative voltage protection)and pin 14 (positive voltage protection).3.3.8.2 VIEWING SAVED SETTINGS1. Pressing ! from the power-up screen displays the Saved Setups screen (Figure 3-8) con-sisting of a list of locations 1 through 20 arranged in two columns of 10 rows. Use T and Rkeys to display additional columns. NOTE: Use the number keys as a shortcut, e.g., press-ing 4 immediately highlights location 41, showing the column with locations 41 through 50.2. Use the U and Y keys to highlight the desired memory location; When the desired locationis highlighted, press !. The details of the parameters listed in Table 3-8 are displayed.3.3.8.3 SAVING SETTINGS AND ERASING OR MODIFYING PREVIOUSLY SAVED SETTINGS1. Press ! from the power-up screen to enter the Saved Setups screen (Figure 3-8).FIGURE 3-8. SAVED SETUPS MENU2. Use the U and Y keys to highlight the desired memory location; To erase a highlightedmemory location, press #. The list will show erased locations as Empty.3. Press ! to see the details stored in the highlighted location.4. Once the details are displayed, use the U and Y keys to highlight the desired parameter.NOTE: If a value to be saved is beyond the range of the unit, the value saved will be limited tothe maximum value. If the Mode is changed, the numerical values for the main andprotection channels must be revised accordingly.• To modify the parameter, press !. Highlight the desired choice from a list, or use thekeypad to enter a numeric value, then press $ to save, or % to abort.• To exit without changing the parameter, press %.VOLTAGESOURCEVOLTAGE CURRENT0.0000 0.0000
