BOP HIPWR 111315 3-473.5.3.1 GPIB PORT SETUPThe following paragraphs describe the how to configure the GPIB port.3.5.3.1.1 CHANGING THE GPIB ADDRESSThe default address is 6. To change the GPIB address press % from the power-up screen,then press ! to enter the Interface menu (see Table 3-16) Highlight GPIB Address and press!, then use the number keys to enter the desired address and press $ to save. Press $ tosave for power-up or % to apply the changes (without saving for power-up) and exit.TABLE 3-16. INTERFACE SETTINGS MENUSETTING CHOICES(BOLD = Factory Default) FUNCTIONInterfaceData FormatSCPICIILSCPI (Standard Commands for Programmable Instruments) - see PAR.3.6. and Appendix B.CIIL - Provides compatibility with early Kepco power supplies and con-trollers.GPIB Address 0 - 30 (06) Assigns address used by external GPIB controller to communicate withBOP.*RST set Output OFFONOFF - Sending *RST causes output to go off (per IEEE 488.2 specifica-tions) (see PAR. 3.5.3.1.3 for details).ON - Sending *RST causes output to go on (see PAR. 3.5.3.1.3 fordetails).Device Clear SCPIMATESCPI - sending Device Clear (DCL) or selected DCL has no effect onoutput voltage and current per IEEE specification 488.2.MATE - When device clear is received, the power supply output is set tozero volts.Serial Baud Rate OFF960019200Selects RS 232 serial port baud rate.Xon/xoff ENABLEDISABLEENABLE - Allows BOP to control when data is received (see PAR.3.5.6.2.1).DISABLE - Disables XON/XOFF. If both Serial XON/XOFF and Promptfunctions are disabled, Echo mode is the default (see PAR. 3.5.6.2.2).Prompt DISABLEENABLEENAB+ECHOENABLE - Enables Serial Prompt (see PAR. 3.5.6.2.3).DISABLE - Disables Prompt. If both Serial XON/XOFF and Promptfunctions are disabled, Echo mode is set (see PAR. 3.5.6.2.2).ENAB+ECHO - Enables Serial Prompt (see PAR. 3.5.6.2.3) and Echo(see PAR. 3.5.6.2.2) modes. Prompt is returned when the unit is readyand any received characters are echoed back to the sender.NOTE: To restore all interface settings defaults, press % from the power-up screen, highlight Interface Settings, press !, thenpress @ to restore defaults shown above in BOLD. Press $ to save for power-up or % to apply the changes(without saving for power-up) and exit.
