Chapter 99-40(around the center). This makes the mounting work easier.F-9-68- Take care so that the bearing of the steering roller does not run over theframe.9.7.3.3 Preparation for Removing the Fixing SeparationRoller Ball Bearing 0014-8539imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Open the front door.2) Pull out the fixing/feeding unit toward you.3) Remove the fixing belt unit. (page 9-38)Reference [Removing the Fix-ing Belt Unit]9.7.3.4 Removing the Fixing Separation Roller BallBearing 0014-8541imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Remove the 2 fixing separation roller ball bearings [1].- 4 E-rings [2]- 2 gears [3]- 1 dowel pin [4]- 2 bearings [5]- 2 spacers [6]F-9-699.7.4 Fixing Roller9.7.4.1 Preparation for Removing the Fixing Roller 0014-0186imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Open the front door.2) Pull out the fixing/feeding unit toward you.3) Remove the fixing main heater/fixing sub heater. (page 9-54)Reference[Removing the Fixing Main Heater/the Fixing Sub Heater]9.7.4.2 Removing the Fixing Roller 0014-0187imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Remove the fixing roller [1].- 2 C-rings [2]- 2 gears [3]- 2 bearings [4]- 2 fixing roller heat insulating bushes [5]- 1 holder [6]Points to Note When Mounting the Fixing Roller- The orientation for mounting the gears [3] and the heat-insulating bushes[5] is specified. Mount them in the orientation shown in the below figure.- When attaching the photosensitive drum, be sure to do it with the shieldingsheet attached. Remove the shielding sheet after you finished attaching it.F-9-709.7.4.3 After Replacing the Fixing Roller 0014-0188imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+- Apply grease (Molykote HP-300; CK-8012) to the inner diameter area [1]and the outer diameter area [2] of the bushings for about 20 mg, so that tomake white coating in assigned areas.Purpose: to avoid abnormal soundThe orientation for mounting the gears is specified. Mount them in the ori-entation shown in the below figure.F-9-71[2][1][1][1][2][2][2][2][3][3] [4][5][5][6][6][1][2][2][3][3][4][4][5][5][6][1] [2]
