Chapter 99-149.3.1.2 Power Save Mode 0012-8134imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / imagePRESS C1+In the case of power save mode (power save mode/low power save mode/sleep mode), target temperature is set low at standby, and power saving is enabled by thefollowing controls:- Stop the drive system- Reduce the power distribution to the heater9.3.2 Detecting the Passage of Paper9.3.2.1 Detection for Paper Wrapping 0013-3429imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / imagePRESS C1+Inside delivery sensor (PS15) detects the paper wrapping over the fixing roller/belt. In the case of detecting the delay of paper lead edge by inside delivery sensor,it is perceived as wrapping jam of the fixing to stop the fixing motor, and separate the fixing belt from the fixing roller. When the jam is cleared after the fixingwrapping jam, it executes the detection of residual paper at the fixing inlet sensor (PS14).F-9-14PS14: Fixing inlet sensorPS15: Inside delivery sensorMode Target Temperature Heater StateFixingRollerExternal HeatRollerFixing Belt Fixing MainHeater (H1)Fixing SubHeater (H2)External HeatRoller Heater(H3)Inlet RollerHeater (H4)Standby Mode 165 deg C 200 deg C 95 deg C OFF ON Alternately lighting of H3 and H4Save EnergyModeSet to -10% 160 deg C 190 deg C - ON OFF ON OFFSet to -25% 140 deg C 160 deg C - ON OFF ON OFFSet to -50% 100 deg C - - ON OFF OFF OFFLow Electricity Mode 100 deg C - - ON OFF OFF OFFSleep Mode - - - OFF OFF OFF OFFPS15PS14
