Chapter 1414-25F-14-34[1] Paper[2] Registration unit7) After tightening the 2 fixing screws loosened in Step 5), close the fixing feed assembly and front cover.8) Following the Steps 1) and 2), output the monochrome halftone test pattern and check the skew amount in the output paper.When the skew amount is large, adjust the amount by repeating Step 3) through Step 8).To output the monochrome halftone test pattern, make a setting in the following service mode.Set the items under COPIER>TEST>PG.When the following setting is made, 10 sheets of the above-mentioned pattern are output from Cassette 1.In this case, set A3-size paper in Cassette 1.TYPE=5COLOR-Y=0COLOR-M=0COLOR-C=0COLOR-K=1PG-QTY=10PG-PICK=1A3-size paper is used in this example.In an actual case, it is recommended to make an adjustment using the paper (paper type, paper size) which is actually used by the user.14.3.2.2 Wrinkle14.3.2.2.1 Wrinkles appear on output paper: Pad cover wears out0018-1585imagePRESS C1 P / imagePRESS C1 / Color Image Reader-H1 / imagePRESS C1 (CUSTOM) / imagePRESS C1+ (Printer) / imagePRESS C1+[ Case in the field ]DescriptionSince wrinkles appeared on printed paper, the pressure pad and pad cover of the fixing belt assembly were replaced with a new one for solution.- The pressure pad is used to form the appropriate fixing nip.Field RemedyWhen wrinkles appear on printed paper, replace the pressure pad and pad cover of the fixing belt assembly with new ones.Reference: After replacing the pressure pad cover, apply silicon oil S-20 to the cover in the width of approx. 200mm from the center of the cover. Whenapplying the silicon oil, make lint-free paper absorb the amount of oil that does not drip off.FL2-5457 Pressure padFL2-2788 Pad coverFY9-6011 LUBE S-20 SILICON OIL (50cc)14.3.2.3 Ripple/Curl14.3.2.3.1 Irregular size heavy paper curls up0019-8274imagePRESS C1 P / imagePRESS C1 / Color Image Reader-H1 / imagePRESS C1 (CUSTOM) / imagePRESS C1+ (Printer) / imagePRESS C1+[2][B] [A][1][B][A][B] [A]
