Chapter 99-41- Make sure to wipe off the excessive grease because the grease adheres tothe both edge [1] of the fixing roller when mounting the greased bushesto the fixing roller.F-9-72When replacing the fixing roller / the fixing belt, or both of them, be sure toclean the surface of the fixing roller and the fixing belt with a lint-free papermoistened with alcohol.Cleaning the Fixing RollerThe fixing roller [2] rotates by turning the fixing motor [1] in the directionshown by the arrow. Clean evenly across the fixing roller with a lint-free pa-per moistened with alcohol while turning the fixing motor [1]. Clean for 1 to2 rotations of the fixing roller [2].F-9-73Cleaning the Fixing BeltThe fixing belt [2] rotates by turning the belt [1] in the direction shown bythe arrow. Clean evenly across the fixing belt with a lint-free paper mois-tened with alcohol while turning the belt [1]. Clean for 1 to 2 rotations of thefixing belt [2].F-9-74Remedy for Fixing Belt ReplacementThe fixing belt may be displaced while rotating. When attaching it, be surethat the fixing belt is located at the center.1) Turn the gear until it stops.If turned in the direction shown by [A], the fixing belt shifts closer to [a]when turning the belt.If turned in the direction shown by [B], the fixing belt shifts closer to [b]when turning the belt.F-9-752) Turn the belt to shift the fixing belt to the center position.Error code:E007 (Belt displacement error)0001 : Front side belt displacement error0002 : Rear side belt displacement error0007 : Detection of displacement error by the double error detection0010 : In the case that after the steering monitor ON, HP detection failedto be within 1 sec.0100/0200 : HP detection error on initialization[1][2][1][1][2][A][B][a][b]
