Chapter 88-63- 1 screw [3]F-8-1213) Remove the pre-fixing/feeding unit [1].3-1) Move it in the direction of the arrow [A], and then, lift it in the directionof the arrow [B] to remove.- 3 E-rings [2]- 2 bearings [3]- 1 gear [4]F-8-122Points to Note When Mounting the Pre-Fixing/Feeding Unit.In the case of mounting the pre-fixing/feeding unit, make sure to execute af-ter passing the harness [1] through a hole of the edge saddle [2].F-8-1238.10.7.3 Removing the Pre-Fixing/Feeding Unit 0020-5129imagePRESS C1+ (Printer) / imagePRESS C1+1) Disconnect the connector [1].2) Remove the fixing pin [2].- 1 screw [3]F-8-1243) Remove the pre-fixing/feeding unit [1].3-1) Move it in the direction of the arrow [A], and then, lift it in the directionof the arrow [B] to remove.- 3 E-rings [2]- 2 bearings [3]- 1 gear [4]F-8-125Points to Note When Mounting the Pre-Fixing/Feeding Unit.In the case of mounting the pre-fixing/feeding unit, make sure to execute af-ter passing the harness [1] through a hole of the edge saddle [2].F-8-1268.10.8 Fixing/Feeder Unit8.10.8.1 Preparation for Pulling/Removing the Fixing/Feeding Unit 0014-0086imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Open the front door.8.10.8.2 Pulling/Removing the Fixing/Feeding Unit 0014-0087imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+[Pulling out the fixing/feeding unit]1) Turn the handle in the direction of the arrow.[2][3][1][A][B][1][2][3][2][2][3][4][1][2][2][3][1][A][B][1][2][3][2][2][3][4][1][2]
