Chapter 99-50F-9-1232) Remove the pressure pad cover [1].- 5 screws [2]F-9-1249.7.13.3 After Replacing the Pressure Pad Cover 0014-6123imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+Before installing a belt, apply silicon oil (S-20; FY9-6011) to the markedarea of the pressure pad cover (within the radius of about 200 mm from thecenter).Apply silicon oil to the pressure pad cover, after soaking lint-free paper intothe oil to the extent that the oil does not drip from the paper.F-9-125[1] pressure pad cover9.7.14 Fixing Main Thermistor9.7.14.1 Preparation for Removing the Fixing MainThermistor 0014-0208imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Open the front door.2) Pull out the fixing/feeding unit toward you.9.7.14.2 Removing the Fixing Main Thermistor 0014-0209imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Detach the fixing upper cover [1].- 2 stepped screws [2]- 1 screw [3]F-9-1262) Remove the fixing main thermistor unit [1].- 1 connector [2]- 1 screw [3]F-9-1273) Remove the fixing main thermistor [1].- 1 screw [2]- 1 mount [3]F-9-1289.7.15 Fixing Sub Thermistor9.7.15.1 Preparation for Removing the Fixing SubThermistor 0014-0210imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Open the front door.2) Pull out the fixing/feeding unit toward you.9.7.15.2 Removing the Fixing Sub Thermistor 0014-0211imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Remove the fixing upper cover [1].- 2 stepped screws [2]- 1 screw [3][2][2][3] [4] [5] [5][7][1][6][1][2][1][1] [2] [3][3][1][2][1] [2][3]
