Chapter 77-106- 1 bushing [4]- 1 gear holder [5]- 1 gear [6]F-7-2337.14.33 ITB Cleaner Brush (Small)7.14.33.1 Preparation for Removing the ITB CleanerBrush (Small) 0013-9723imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Open the front cover.2) Detach the process unit cover.3) Lift the hopper unit.4) Remove the primary charging assembly. (page 7-86)Reference [Re-moving the Primary Corona Assembly]5) Remove the pre-transfer charging assembly. (page 7-88)Reference [Re-moving the pre-transfer corona assembly]6) Remove the drum unit. (page 7-89)Reference [Removing the DrumUnit]7) Pull out the fixing/feeding unit.8) Remove the intermediate transfer unit. (page 7-100)Reference [Remov-ing the Intermediate Transfer Unit]9) Remove the ITB cleaning unit. (page 7-99)Reference [Removing theITB Cleaning Unit]10) Remove the ITB cleaner brush (large). (page 7-105)Reference [Re-moving the ITB Cleaner Brush (Large)]7.14.33.2 Removing the ITB Cleaner Brush (Small) 0013-9724imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Remove the ITB cleaner brush unit [1] by shifting it in the direction of ar-row.F-7-2342) Remove 2 E-rings [1], 1 bearing [2], 1 bushing [3], and 1 gear [4].F-7-2353) Remove the ITB cleaner brush (small) [1] by shifting it in the direction ofarrow.- 1 bushing [2]- 1 bearing [3]F-7-2367.14.34 Secondary Transfer Roller Brush (Upper)7.14.34.1 Preparation for Removing the SecondaryTransfer Roller Brush (Upper) 0013-9773imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Open the front cover.2) Pull out the fixing/feeding unit toward the front.3) Remove the secondary transfer outside roller unit. (page 7-101)Refer-ence [Removing the Secondary Transfer Outer Roller Unit]4) Remove the secondary transfer outside roller sub-unit. (page 7-102)Ref-erence [Removing the Secondary Transfer Outside Roller Sub-Unit]5) Remove the secondary transfer outside roller. (page 7-104)Reference[Removing the Secondary Transfer Outside Roller]7.14.34.2 Removing the Secondary Transfer Roller Brush(Upper) 0013-9774imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Remove the washer [1].- 1 screw [2]F-7-2372) Remove the secondary transfer roller brush (upper) [1].- 3 E-rings [2]- 1 gear [3]- 2 bearings [4]F-7-238[2][2] [3][3][4][5][6][1][2][1][1][1][2] [3][4][1][2][3][2][1][1][2][2][2][3][4][4]
