Chapter 99-55F-9-1527) Move the 2 mounts [1] in the direction of the arrow [A] respectively, andthen, remove them in the direction of the arrow [B].- 3 fixing screws [2] of the fixing heater- 2 screws [3] (loosen)F-9-153After removing 3 screws [1], make sure the three terminals [3] of the fixingmain heater and the fixing sub-heater will be unattached to the three bosses[2].Leaving the terminals attached to the bosses may cause the terminals to bedamaged, when removing the fixing roller unit.F-9-1548) Remove the fixing roller unit [1] in the direction of the arrow.F-9-1559) From the fixing roller unit, remove the fixing main heater/fixing sub heat-er [1] in the direction of the arrow.F-9-156Points to Note when Attaching / Detaching the Fixing Main Heat-er / Fixing Sub-HeaterHold the white part [2] of the fixing main heater and the fixing sub-heater [3]when handling them.To hold other parts of these heaters place a piece of paper [1] underneaththem.F-9-1579.7.23 Inlet Heater9.7.23.1 Preparation for Removing the Fixing Belt InletHeater 0014-0227imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Open the front door.2) Pull out the fixing/feeding unit toward you.3) Remove the fixing belt unit. (page 9-38)Reference [Removing the Fix-ing Belt Unit]9.7.23.2 Removing the Fixing Belt Inlet Heater 0014-0228imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Remove the 2 heater fixing holders [1].- 2 screws [2]F-9-1582) Pull out the fixing belt inlet heater [1] in the direction of the arrow.[4] [4] [4][2][3][1][2] [2][A] [A][3][3][1][B] [B][1][2][3][1][3][3][1][2][1][1][1] [2][3][1][1][2][2]
