Chapter 1010-34F-10-14210.5.18 Decurler Driver PCB10.5.18.1 Removing the Decurler Driver PCB 0013-9776imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Open the front cover [1] and remove the left lower cover [2].- 5 screws [3]F-10-1432) Remove the decurler driver PCB [1].- 7 connectors [2]- 6 screws [3]F-10-14410.5.19 Side Driver PCB10.5.19.1 Preparation for Removing the Side Driver PCB0013-9397imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Remove the right rear upper cover. (page 10-12)Reference [Removingthe Right Rear Upper Cover]10.5.19.2 Removing the Side Driver PCB 0013-9398imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Open the right upper cover [1] and remove one screw [2].F-10-1452) Remove the connector blanking cover [1].- 1 screw [2]F-10-1463) Remove one grounding terminal screw [1], and remove one reuse band[2].4) Remove the harness [4] from one wire clip [3], and remove one connector[5].F-10-1475) Remove the sheet metal [1].- 5 screws [2]When removing the sheet metal [1], the primary suction fan air filter maycome down. The air filter convex area is turned up, so be careful at installa-tion.[1][2][2][2][2][3][3][3][3][4][3][1][2][1][3] [3][3] [3][3][3][2][2][2] [2][1][2][1][2][1][2][3][4][5]
