Canon imagePRESS C1 P Service Manual

Also see for imagePRESS C1: User guide User guide INSTALLATION PROCEDURE

Contents

Canon imagePRESS C1 P Service Manual Manual pdf 134 page image

Chapter 22-402.2.12 Mounting the Balancing Cylinder 0020-4620imagePRESS C1+ (Printer) / imagePRESS C1+1) Take out the balancing cylinders from the attached packing box.2) Remove the developing assembly cover [1].- 1 screw [2]F-2-823) Hold the gear at the developing assembly [1], and manually turn the de-veloping rotary [2] counterclockwise, then with the balancing cylinderupward, fix [A] and [B] aligned as instructed in the figure.F-2-83F-2-844) Open the 2 developing assembly fixing arms [1].- 2 screws [2]F-2-855) Attach the balancing cylinder [1] to the developing rotary. Make sure thatthe pin [2] at the Balancing Cylinder is found in the hole located at thebackside of the developing rotary [3].- Balancing cylinder [1], is a parts to maintain the balance in the innerRotary. Make sure to install it before installing the developing assembly.- The position for Balancing cylinder [1] installation is in the area with notoner supply.CMY LBk[1]Balancing Cylinder[2] [1][1][2]In the case of turning the developing rotary, make sure that the developingassembly fixing arm is fixed with the screw.In the case of attaching the balancing cylinder, make sure not to bump intothe ATR sensor shutter [1].[A][B][2][1][2][1][1]