Chapter 22-282.2 Unpacking and Installation2.2.1 Points to Note Before Starting the Work 0012-6079imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+When installing the machine, keep the following in mind.2.2.2 Unpacking 0012-6120imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Unpack the machine, and remove the plastic cover.2) While pushing against the leaf spring [2] in the grip opening [1] on theright side of the machine using a flat-blade screwdriver, fit in the 2 grips[3].F-2-203) Hold the grips on the left side (front, rear) of the machine, lift the machineslightly to remove the 2 pads [1].At this time, move the plastic bag in the direction of the arrow.(machine weight: about 310 kg)F-2-21- If the machine is moved from a cold to warm place, condensation canoccur. If condensation occurs, image faults can occur. Before starting thework, unpack the machine, and leave it for 1 hour or more so that it becomesused to the room temperature.(Condensation: If a piece of metal s moved from a low to warm place, themoisture in the air around them becomes cooled rapidly, turning into dropsof water on the metal surfaces.)- Since the main body weighs approximately 310 kg, unpacking must bedone by 4 or more persons.- Be sure to turn the 2 adjusters (2 on the front) at the bottom of the machineclockwise to release. When moving the machine, adjusters may come offdue to vibrations. Be careful not to lose the adjusters.Check to make sure that the rear of the claw [4] of the grip is hooked on theplate.Check to be sure that the caster [1] has not dropped off the skid [2] and hasnot ridden over the edge [3] of the side.[1][3][4] [4][2][1][1][2][3]
