Chapter 1111-416) Press [MEAPSAFE].F-11-597) Press the 1 key on the control panel keypad to change the setting to '1'; then, click [OK] button.F-11-608) Check that the notation 'MPSF' has appeared in the lower right corner of the screen; then, turn off and then on the main power.F-11-61If you want to end safe mode, repeat the steps but change '1' to '0' in step -7 and turn off and then on the main power.11.1.28 Setting HTTP port for MEAP application (level 2) 0018-6640imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / imagePRESS C1+For the ports in which the MEAP application uses, the default is 8000 for the port on HTTP server, and 8443 for the port on HTTPS server. In the case that theseports have already used by the customer who is to introduce this application, the MEAP application cannot use the HTTP (or HTTPS) server(s).By changing the following ports to use, however, the MEAP application can be used as well as the existing system.HTTP serverSetting value is 0 through 65535 [the value at factory shipment/after clearing RAM: 8000]HTTPS serverMEMO:-Do not use port number"8080" when PS print server unit is connected.-If the port is used, you can not see the page for RUI of the device with MEAP authentication application.(port "8080" is reserved for redirecting from PS print server unit to device.)
