Chapter 1010-8T-10-5*1: When the DADF is mounted.*2: The same can be said at the time of standby, warm-up, and recovery.10.4.2 Protection Function10.4.2.1 Protective Functions 0014-1316imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / imagePRESS C1+The machine's DC power supply PCB and those of its accessories are equipped with protective functions against excess current and voltage, which will automati-cally cut off the output voltage in response to an error power condition (caused, for example, by a short-circuit on a load).If any of these protective mechanism has gone on, turn off the main power switch of the printer unit, and remove the cause of activation; then, leave the machinealone for about 3 min, and turn its power back on to reset it.10.4.3 Backup Battery10.4.3.1 Backup Battery 0014-1317imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / imagePRESS C1+The SRAM PCB and the DC controller PCB of the machine's main controller PCB are equipped with a lithium battery (1 pc. each) serving as a backup source ofpower in the event of a power shortage or when the power plug is removed.T-10-6LISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.Do not use a battery which is not of a type specifically indicated (same name, or equivalent).Dispose of any used battery according to the instructions of its manufacturer.10.4.4 Energy-Saving Function10.4.4.1 Overview 0014-1318imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / imagePRESS C1+1. Standby ModeThe machine is in operation or is ready to start operation, with all its loads supplied with power.2. Power Save ModeThe machine deceases the control temperature while the fixing assembly is in a standby state according to the selected power save rating (variable through 'changepower save mode' in user mode; default: -10%), thus decreasing the power consumption.Conditions Initiating a Shift from Standby Mode (standby -> power save)Operation mode Main power SWOFF Deep sleep Shallow sleepLow power (&power saving) Door open Fixing error Print (*2)Main power switch OFF ON ON ON ON ON ONAll-night 3.3VR OFF ON ON ON ON ON ONNon-all-night 13VA OFF OFF ON ON ON ON ON13VB OFF OFF ON ON ON ON ON13V4A OFF OFF OFF OFF ON ON ON24V1x OFF OFF OFF ON ON ON ON24V2x OFF OFF OFF ON ON ON ON24V3x (DC relay) OFF OFF OFF ON OFF ON ON24V4x OFF OFF OFF OFF ON ON ONAC relay OFF OFF OFF ON ON OFF ONSub power supply(24V) OFF OFF OFF ON ON ON ONOptional powersupply (24V) *1 OFF OFF OFF ON ON ON ONSRAM PCB manganese dioxide lithium battery (3 V, 100 mAh)DC controller PCB lithium battery (3 V, 6000 mAh)Life 10 yr or more (true of both; with power plug removed)Replacement not possible in the field on its own.
