Chapter 77-100F-7-2027.14.24 Intermediate Transfer Unit7.14.24.1 Preparation for Removing the IntermediateTransfer Unit 0014-0074imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Open the front door.2) Detach the process unit cover.3) Lift the hopper unit.4) Remove the primary charging assembly. (page 7-86)Reference [Re-moving the Primary Corona Assembly]5) Remove the pre-transfer charging assembly. (page 7-88)Reference [Re-moving the pre-transfer corona assembly]6) Remove the drum unit. (page 7-89)Reference [Removing the DrumUnit]7) Pull out the fixing/feeding unit.7.14.24.2 Removing the Intermediate Transfer Unit 0014-0075imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Remove the high voltage connector cover [1].F-7-2032) Disconnect the 3 connectors [1].F-7-2043) Free the 2 harnesses [1] from the harness guide [2].4) Remove the ITB fan duct cover unit [3].- 2 screws [4]F-7-2055) Remove the ITB drive unit [1].- 5 connectors [2]- 4 screws [3]F-7-2066) Remove the intermediate transfer unit [1].- 1 connector [2]- 1 screw [3]F-7-207Points to Note When Mounting the Intermediate Transfer UnitMake sure to move in the direction of the arrow with the intermediate trans-fer unit [2] on the rail [1] of the host machine.FRONT REAR[1][1][1][1][3][4][2][4][1][2][3][2][2][2][3][3][1][2][3]
