Chapter 22-71setting position of the slide guide [2].F-2-232Move the slide guide toward the rear = left margin decreasesMove the slide guide toward the front = left margin increases4) Tighten the screw loosened at step 3), and fix the slide guide.5) Check to be sure that the left margin of image printed from the manualfeed tray is L1 = 2.5 +/-1.5 mm.F-2-233[1] Feeding direction of paper2.2.42 Adjusting Margin along Leading Edge of Image 0012-9077imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+Adjusting method of margin along leading edge of image from each pickupslot is described below.1) Select COPIER > ADJUST > FEED-ADJ > REGIST from the servicemode.2) Adjust by changing the setting.(Each 1 setting value change results in the movement of 0.1 mm. Theimage shifts toward the leading edge by setting the value larger.)3) To activate the setting value, follow the shutdown sequence and turn OFF/ON the main power switch.4) Make sure that the margin along leading edge of image of which paperwas fed from each cassette / deck is L2 = 3.0 +1.5/-1.0 mm.F-2-234[1] Feeding direction of paper2.2.43 Cleaning the Charging Assembly 0014-3040imagePRESS C1 P / imagePRESS C1Perform the following procedure when image fault (vertical or horizontallines) occurs.1) Open the front doorF-2-2352) Remove the cover [1] of the process unit.- 4 screws [2]F-2-2363) Pull the shutter lever [1]found at the hopper fully toward youF-2-2374) Open the toner replacement cover [1]F-2-2385) Remove the hopper cover (Right) [1].- 1 screw [2][1][2]imageL1[1]imageL2[1][1][1][2][1][1]
