Chapter 1515-2315.3 Error Codes (SEND)15.3.1 End Code Items 0012-0888imagePRESS C1 P / imagePRESS C1T-15-7Cause Remedy# 001Indicates that different sizes of originals were scanned while media size is not setas mix mode switch.Check the original and the settings, and then repeat the operation.Indicates that different sizes of originals were scanned by duplexing mode whilemedia size is not set as mix mode switch. Check the original and the settings, and then repeat the operation.# 009Indicates paper-out. Supply media.Indicates that the cassette is not set properly. Set the cassette properly.# 037Indicates that reception failed due to low available memory. Delete the error or unnecessary documents to increase available memory.# 099Indicates that copy/print was interrupted. Repeat the copy/print job.# 701Indicates that Department ID registered at introduction of the job does not existor password is changed.Enter the correct department ID or password from numerical keypad and then sendthe job again.Indicates that Department ID or password is changed during execution of the jobor non-regular ID print job reception setting is deactivated.Contact the system administrator.# 703Writing is not possible because the image area of memory is full.1) Wait a while. Try again after another transmission job has ended.2) Delete the files from the box. If the symptom still appears, turn off and then onthe machine's main power.# 711Indicates that the Box memory is full. Delete the documents within the Box.# 712Indicates that the Box document is full. Delete the documents within the Box.# 749Indicates the failure of job execution as service call is displayed.Turn OFF the main power switch, wait for 10 sec or more, and then turn ON themain power switch. If the machine still does not operate properly, turn OFF themain power and plug off the power cord. Then contact the Service.# 759Indicates that an error occurred when sending the URL of the Box in whichdocument is stored. Contact the system administrator.# 816Indicates that the print job failed as it exceeded the value to restrict the printableside set in the departmental ID administration. Contact the system administrator.# 849Indicates that the machine failed to deliver the device information as the externalphone (destination device) is under other job operation. Deliver the device information again after job by the external phone (destination)# 850Indicates that the machine failed to deliver the device information as the displayrelated to the transmitted information in the external phone (destination device) isunder operation.Check the device information that was not delivered, and then deliver it again.# 851Indicates that there is insufficient memory. Check the memory level of the machine and delete unnecessary documents in thebox.
