Chapter 77-92F-7-1512) Detach the seal support plate (rear) [1].- 2 screws [2]F-7-152When Mounting the Seal Support Plate (Front/Rear)- When mounting the seal support plate (front/rear), make the seal supportplate [2] on the scoop-up sheet [1].F-7-153- When attaching the seal support plate (rear) [1], be sure to support the areashown in [2] so that the seal support plate (rear) is not tilted.F-7-1547.14.15 Scoop-Up Sheet Support Plate7.14.15.1 Preparation for Removing the Scoop-Up SheetSupport Plate 0013-9790imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Open the front cover.2) Remove the process unit cover.3) Hold up the hopper unit.4) Remove the primary corona assembly. (page 7-86)Reference [Remov-ing the Primary Corona Assembly]5) Remove the pre-transfer corona assembly. (page 7-88)Reference [Re-moving the pre-transfer corona assembly]6) Detach the drum unit. (page 7-89)Reference [Removing the Drum Unit]7) Detach the photosensitive drum. (page 7-90)Reference [Removing thePhotosensitive Drum]8) Detach the drum cleaning pre-exposure LED unit. (page 7-86)Reference[Removing the Drum Cleaning Pre-Exposure LED Unit]7.14.15.2 Removing the Scoop-Up Sheet Support Plate0013-9791imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Detach the scoop-up sheet support plate [1].- 2 screws [2]F-7-1557.14.16 End Seal (Front)7.14.16.1 Preparation for Removing the End Seal (Front)0013-9741imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Open the front cover.2) Detach the process unit cover.3) Hold up the hopper unit.4) Remove the primary corona assembly. (page 7-86)Reference [Remov-ing the Primary Corona Assembly]5) Remove the pre-transfer corona assembly. (page 7-88)Reference [Re-moving the pre-transfer corona assembly]6) Detach the drum unit. (page 7-89)Reference [Removing the Drum Unit]7) Detach the drum cleaning blade. (page 7-93)Reference [Removing theDrum Cleaning Blade]7.14.16.2 Removing the End Seal (Front) 0013-9742imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Remove the end seal (front) [1].- 1 screw [2]F-7-1567.14.17 End Seal (Rear)7.14.17.1 Preparation for Removing the End Seal (Rear)0013-9743imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Open the front cover.2) Detach the process unit cover.3) Hold up the hopper unit.[2] [3][4][4][4][1][2][2] [1][1][2][1][1][1][2][1][2][1][1] [2][2][1]
