Chapter 77-104F-7-2242) Shift the primary transfer roller [1] in the direction of the arrow [A] andthen [B], and remove the roller.F-7-2257.14.29 Secondary Transfer External Roller7.14.29.1 Preparation for Removing the SecondaryTransfer Outside Roller 0013-9769imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Open the front cover.2) Pull out the fixing/feeding unit toward the front.3) Remove the secondary transfer outside roller unit. (page 7-101)Refer-ence [Removing the Secondary Transfer Outer Roller Unit]4) Remove the secondary transfer outside roller sub-unit. (page 7-102)Ref-erence [Removing the Secondary Transfer Outside Roller Sub-Unit]7.14.29.2 Removing the Secondary Transfer OutsideRoller 0013-9770imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Remove the secondary transfer outside roller [1].- 3 E-rings [2]- 2 bearings [3]- 1 curler [4]- 1 gear [5]F-7-2267.14.30 Secondary Transfer Internal Roller7.14.30.1 Preparation for Removing the SecondaryTransfer Inside Roller 0013-9717imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Open the front cover.2) Detach the process unit cover.3) Lift the hopper unit.4) Remove the primary charging assembly. (page 7-86)Reference [Re-moving the Primary Corona Assembly]5) Remove the pre-transfer charging assembly. (page 7-88)Reference [Re-moving the pre-transfer corona assembly]6) Remove the drum unit. (page 7-89)Reference [Removing the DrumUnit]7) Pull out the fixing/feeding unit.8) Remove the intermediate transfer unit. (page 7-100)Reference [Remov-ing the Intermediate Transfer Unit]9) Remove the ITB cleaning unit. (page 7-99)Reference [Removing theITB Cleaning Unit]10) Remove the ITB. (page 7-102)Reference [Removing the ITB]7.14.30.2 Removing the Secondary Transfer Inside Roller0013-9718imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+1) Release 2 tension roller pressure arms [1] by pressing the knob [2], andshift the arm in the direction of the arrow.F-7-2272) Remove the secondary transfer inside roller [1].Cover the roller section of the secondary transfer inner roller with paper, toavoid touching it directly.- 2 E-rings [2]- 1 bearing [3][1][1][A][B][1][2][2][2][3][3][4][5][1][1][2][2]
