Chapter 22-44F-2-98F-2-9911) Repeat the step 2) to 10) to set the 4 developing assemblies to the devel-oping rotary.2.2.14 Mounting the Developing Assembly 0020-4621imagePRESS C1+ (Printer) / imagePRESS C1+1) Take out the developing assembly (yellow, magenta, cyan, black, andclear) from the auxiliary package.To set developing assembly to developing rotary, please follow the belowsteps.2) Hold the gear at the developing assembly [1], and manually turn the de-veloping rotary [2] counterclockwise, then with the installed color up-ward, fix [A] and [B] aligned as instructed in the figure.- When touching the developing assembly, check to make sure that yourhands are free of foreign matter (especially metal pieces), then start thework. (If there is foreign matter on your hand, it may cause image fault.)- When you hold developing assembly, make sure that you don't touchdeveloping cylinder.To set developing assembly to developing rotary, refer to the followingsteps, Bk developing assembly [1] -> Y developing assembly [2] -> Mdeveloping assembly [3] -> C developing assembly [4] -> L (Clear)developing assembly [5].[1][A] [A][B] [B][1][2] [2]The developing positioning sheet for each color is attached to [A] of therespective developing rotary. Attach the developing assembly according toeach positioning sheet.If turning the developing rotary clockwise while the developing assembly isfitted, the toner blocking sheet which is attached to the sleeve of thedeveloping assembly may come off because of intervention with thephotosensitive drum. The developing rotary must be turnedcounterclockwise.CMY LBk[4][2] [5][1][3] Balancing CylinderCKMYL[A]
