Chapter 55-50F-5-25620) For the subsequent steps, see step 20 to 33 in 'Removing the ScannerDrive Wire' (in case of imagePRESS C1 Series).5.4.13.4 Attaching the Scanner Drive Wire (imagePRESSC1 Series/imagePRESS C7000 Series) 0014-1578imagePRESS C1 / Color Image Reader-H1 / imagePRESS C1+1) Put the ball of the wire into the hole on the drive pulley[1] and wind thewire around it (inner side 4 turns, outer side 5 turns), then fix it with thetape etc. At this time, wind it with the wire retaining fixture [2] inside(same as shown below).2) Hook the wire onto each pulley and then fix one end onto the hook[3] atthe left side and the other end onto the hook[4] at the right side temporar-ily.3) Temporarily fix the wire fixing plate [2] to the primary mirror mount [5].4) Attach the reader upper frame.F-5-257F-5-2585.4.13.5 Adjustment of Positions of the Mirror 1, 2 Mount(imagePRESS C1 Series/imagePRESS C7000 Series)0014-1619imagePRESS C1 / Color Image Reader-H1 / imagePRESS C1+1) Arrange the pin position for rear on the mirror positioning tool (FY9-3009-040) from the initial position to the operational position.F-5-2592) Arrange the pin position for front on the mirror positioning tool from theinitial position to the operational position.[1] [2][2][4][4][5][3][3][1][1][2][2][4][4][5][A][A][B][B][C]
