96English■ Ping test pageThis page makes it possible to check whether thenetwork is connected to the DNS server, etc.Click [Detailed set up] → [Ping test].Enter the IP address of the server to be tested.Button for conducting the testDisplay which appears when the connection wassuccessful.Display which appears when the connection failed.■ Command port set up pageSet the port number to be used with command control.Click [Detailed set up] → [Command port set up].Input the port number to be used with commandcontrol.Setting update button.■ Status notification set up pageSets the IP address and port number of the PC where“Multi Monitoring & Control Software (see page 91)” isoperating when informing the PC of the status of thisunit.Click [Detailed set up] → [Status notification set up].When the status notification is set, if the unit ismalfunctioning and its power indicator is blinking red,the trouble content can be recognized even at a remotelocation where the power indicator cannot be directlychecked.Selection field of status notificationIP address input field for notification destination PCPort number input field for notification destinationPCUpdate button for the settings■ SNMP set up pageSets the various items for SNMP.SNMP (Simple Network Management Protocol) is aprotocol to manage devices connected to the network.If the SNMP manager is used for connection, theinformation of the target device can be obtained, and itssettings can be changed.Click [Detailed set up] → [SNMP set up].[SNMP]:Select the SNMP version to use.[SNMP v1/v2c] [COMMUNITY][COMMUNITY NAME]:Enter the community name of SNMP v1/v2c.[PERMISSION]:Select whether to obtain only information via SNMPv1/v2c or to both obtain information and make thesetting.
