Panasonic TH-98SQ1W Operating Instructions Manual

Also see for TH-86SQ1W: Operating instructions Operating instructions Operating Instructions - Basic Guide Operating instructions Operating instructions

Contents

Panasonic TH-98SQ1W Operating Instructions Manual Manual pdf 30 page image

30EnglishIdentifying ControlsDisplay198-inch model86-inch model● Slide the lever on the rear panel to eject the powerindicator and remote control sensor.To store them, slide the same lever, or directly push inthe bottom surface of the remote control sensor.Note● For normal use, pull out the power indicator andremote control sensor from the edge side of themain unit by operating the lever on the rear panel.Depending on the setup condition such as whenusing multi screen display of the multi display, storethem in the main unit.1 Power Indicator / Remote control sensorThe Power Indicator will light.When the power of the unit is ON (Main Power On/ Off button: ON)● Picture is displayed: green● When the unit enters the standby mode using thefollowing functions: orange (red / green)• Standby state with the “Power management”functionAbout “Power management” function, see page 64.• Standby state with [HDMI-CEC control] set to[Enable] and at least one [Link function] set toother than [Disable]About [HDMI-CEC control] setting and [Linkfunction], see page 66.• Standby state with [Network control] set to [On]About “Network control” settings, see page 72.• Standby state during schedule play modeAbout “Schedule play mode”, see page 111.● Standby state in conditions other than the above:redWhen the power of the unit is OFF (Main PowerOn / Off button: OFF): No lightNote● Even if the unit is turned off with the powerindicator off, some of the circuits are in power-onstatus.● When the power indicator is orange, powerconsumption during standby is generally largerthan that of when the power indicator is red.