|
42EnglishAdjusting Position1 Press to display the[Position] menu.0000150PositionDefault DefaultAuto setupH-positionH-sizeV-positionV-sizeClock phaseDot clockPC auto setting OffOver scan Off2 Select the item to adjust with .● Unadjustable items are greyed out.Adjustable items differ depending on the signal,input and the display mode.3 Adjust with .4 Press to exit from adjustmode.■ To return to the previous screenPress .■ To reset to defaultsWhen [Default] is selected, pressing resetsthe adjustment values of all the displayed menus todefault.When adjusting each item, pressing resets the adjustment value of the item to default.Note● Settings for [Position] are memorised separately foreach input signal.Setting [Position] when the display is installedverticallyEven if the display is installed vertically, when [Imagerotation] is set to [Off], the adjustment direction of theposition and size is the same as that of horizontalinstallation. When [Image rotation] is set to [180degrees], the adjustment direction becomes oppositeof that in [Off] state. (see page 79)Note these points for adjustment.Auto setupWhen inputting a PC signal, [H-position] / [V-position],[H-size] / [V-size], [Clock phase] and [Dot clock] areautomatically corrected.This setting is enabled under the followingcondition:● This setting is enabled when an analogue signal(PC) is input and the aspect mode is set to [Full].(see page 82)While displaying the picture of the correspondingsignal, select [Auto setup] and press .Using Remote ControlPress .When Auto Setup does not work, [Invalid] isdisplayed.Note● When the dot clock frequency of a PC signal is 162MHz or higher, [Clock phase] and [Dot clock] cannotbe automatically corrected.● Auto Setup may not work when a cropped or darkimage is input. In such case, switch to a bright imagewith borders and other objects are clearly shown, andthen try auto setup again.● Depending on the signal, out of alignment may occurafter Auto Setup. Carry out fine tuning for the position/size as required.● If the automatic position adjustment is not optimizeddepending on the signal, switching the [Inputresolution] (see page 56) setting may be able toperform the automatic position adjustment properly.● Accurate auto setup is not possible when a signalsuch as additional information is superimposed outof valid image period or when intervals betweensynchronizing signal and image signal are short.Also, accurate auto setup is not possible when imagesignals with tri level synchronizing signal added areinput.● When [PC auto setting] is set to [On], automaticposition adjustment starts under the followingconditions:• When the display power is turned ON.• When the input signal is switched.● If Auto Setup does not work well, select [Default],press , and then adjust the position/sizemanually.
|
