Panasonic TH-98SQ1W Operating Instructions Manual

Also see for TH-86SQ1W: Operating instructions Operating instructions Operating Instructions - Basic Guide Operating instructions Operating instructions

Contents

Panasonic TH-98SQ1W Operating Instructions Manual Manual pdf 58 page image

58English■ [Initial VOL level]Sets the sound volume when [Initial VOL function] isenabled.Note● The sound is output with the set volume when [InitialVOL function] on the menu is in [On] state.● When [Maximum VOL function] is set to [On], thevolume cannot be set to the level higher than the levelset for [Maximum VOL level].■ [Power ON screen delay]When multiple displays are installed and are turnedon simultaneously, this function distributes the loadof power by delaying the power supply timing of eachdisplay. Setting is required for each display.[Off]:The powers are supplied at the same time aspower-on.[Auto]:The delay time is automatically set according to thenumbers set for display IDs.The delay time is determined by multiplying adisplay ID by 0.3 seconds.Example: If the display ID is 3, the delay time is 0.9seconds.1 - 30:Sets the delay time (sec.). The powers aresupplied to the display with the set time of delayafter power-on.Note● The power indicators blink green from start to end ofthe delay operation process.● This function also works when the power plug isinserted/extracted, or when the power is restoredfrom instantaneous interruption due to blackout, etc.■ [Information(No activity power off)]Sets the display/non-display of the no-activity-auto-power-off warning message when the power is turnedon.[On]:The warning message is displayed when the poweris turned on.[Off]:The warning message is not displayed when thepower is turned on.Note● This setting is enabled when [No activity power off] is[Enable]. (see page 69)■ [Information(Power management)]Sets the display/non-display of a message thattells the power has been turned off by the powermanagement function when the power is turned on.[On]:The message is displayed when the power isturned on.[Off]:The message is not displayed when the power isturned on.Note● This setting is enabled when “Power management”function is [On]. (see page 64)Input searchWhen a signal is not detected, another input with asignal is automatically selected.Input searchInput search1st search input2nd search inputCustom(None)(None)■ [Input search][Off]: When there is no signal, the input isnot switched automatically.[Allinputs]:Searches all inputs and switches to aninput with a signal.Input search is executed in thefollowing order.Example: When the current input isHDMI1[HDMI2] → [DisplayPort] → [DIGITALLINK] → [DVI-D] (or [SLOT]) → [PC]→ [USB] → [HDMI1] →Note● The inputs set to [(Skip)] in [Input label] (see page 63)are skipped when searching.[Custom]: Repeatedly searches [Current input],[1st search input] and [2nd searchinput] in order, and switches to an inputwith a signal.[Inputdetection]:Monitors the inputs set to [On], detectthe status change from no signal tosignal present, and switches to theinput.PCSearching...[Searching...] is displayed during the input search.