Panasonic TH-98SQ1W Operating Instructions Manual

Also see for TH-86SQ1W: Operating instructions Operating instructions Operating Instructions - Basic Guide Operating instructions Operating instructions

Contents

Panasonic TH-98SQ1W Operating Instructions Manual Manual pdf 35 page image

35EnglishSelecting the input signalSelect the signals input to the unit.Press or .UnitMENU ENTERINPUT + -Switches input every time the buttons are pressed.PCFull[HDMI1] → [HDMI2] → [DisplayPort] →[DIGITAL LINK] → [DVI-D] (or [SLOT]) → [PC] →[USB] → [MEMORY VIEWER][HDMI1]: HDMI 1 terminal, HDMI input[HDMI2]: HDMI 2 terminal, HDMI input[DisplayPort]: DisplayPort IN terminal, DisplayPortinput[DIGITAL LINK]: DIGITAL LINK terminal, DIGITAL LINKinput[DVI-D]*: DVI-D IN terminal, DVI-D input[SLOT]*: Input signal of the function board[PC]: PC IN terminal, PC input[USB]: USB terminal, USB input[MEMORY VIEWER]: USB terminal, “Memory viewer”input*: For [DVI-D] and [SLOT] input, either one selected forthe [DVI-D/SLOT select] setting is displayed. (seepage 82)Note● Displays the signal name as set in [Input label]. (seepage 63)● Input will not be switched unless [Input lock] is set to[Off]. (see page 69)● Image retention (image lag) may occur on the LCDliquid crystal panel when a still picture is kept onthe panel for an extended period. To prevent such aproblem, using the screensaver and the [Wobbling]function is recommended. (see page 62, 63)RECALLIt is possible to check the setting status of input label,picture mode, etc.Press .Current setting status will be displayed.10:0012783456HDMI1FullAUDIO IN1Memory name: MEMORY2Schedule play modeOff timer 90 minBackup mode OK1 Input label2 Aspect mode (see page 37)3 Backup input change (see page 61, 62)4 Audio input (see page 66)5 Profile name (see page 49)6 [Schedule play mode] (see page 111)7 Off timer remaining time (see page 36)8 Clock / Mute (see page 36, 71)● When there is no video signal to the selected input,[No signal] is displayed for about 30 seconds at theend.● When a USB memory is not connected to the USBterminal at the time of switching to the USB input, [Noexternal media] is displayed for about 30 seconds.Even when a USB memory is connected, if it does notcontain any playable file, [No play file] is displayed atall times.● When [No signal image settings] - [Display setting] isset to [On] (see page 68), the message [No signal] /[No external media] / [No play file] are not displayed.Instead, the image set in [No signal image settings]will be displayed.● To display the clock, set [Date and time] and then set[Clock display] to [On]. (see page 70)