123English8 Select [Yes] with and press.Data cloning to the display starts.Data from USB memoryDo you copy the data ?Yes NoThe following message is displayed after datacloning has finished.Cloning finished. Please turn off the power.9 After data cloning has finished,remove the USB memory device fromthe USB terminal.10 Switch the button> ( ) on the unit to ( ) to turnthe power off.The cloned content is applied to the display.● If the is locked,please disconnect the AC cord plug from the walloutlet.● When USB memory is not removed in the step 9,the message [Select copy type] is displayed whenthe display is turned on again.Note● If the data is copied with [POWER button lock] set to[On], this function operates after turning the poweroff, and the cannot beused to turn the power on. In this case, remove thepower plug, wait sufficient time, and then connect thepower plug again to turn the power on.Copying data to other display viaLAN1 Display [Setup] menu pressing.2 Select [Options] with and press.The following display appears.OptionsDisplay informationSoftware licensesCloning passwordUSB data cloningShippingLAN data cloningOutput log data3 Select [LAN data cloning] withand press .[Cloning password] screen is displayed.4 Enter the cloning password, and thenpress .[LAN data cloning] screen is displayed.5 Select [Select display] with andpress .Displays on the same subnet are listed.LAN data cloningExecuteSelect displayWrite protectStatus Display name IP addressOff6 Select the display to copy the data towith and press <VOL +>.Select all the displays to copy the data to.SQ1-001 192.168. 0. 1192.168. 0. 2192.168. 0. 4192.168. 0. 25192.168. 0. 31192.168. 0. 7192.168. 0.124192.168. 0.211SQ1-002SQ1-004SQ1-005SQ1-014SQ1-006SQ1-041SQ1-009Select displayPlease check the display to register.Check Display name IP address7 Press .
