Panasonic TH-98SQ1W Operating Instructions Manual

Also see for TH-86SQ1W: Operating instructions Operating instructions Operating Instructions - Basic Guide Operating instructions Operating instructions

Contents

Panasonic TH-98SQ1W Operating Instructions Manual Manual pdf 121 page image

121EnglishUsing data cloningMenu settings and adjusted values of a single displaycan be copied to multiple displays by using a USBmemory or via LAN.Note● If the sizes of the displays are different, the cloningfunction does not operate. Use the common sizeddisplays.● Set the input to something other than [USB] or[MEMORY VIEWER], and perform the data cloning.● The cloning password is the one set for [Cloningpassword].● The initial password in the factory default state is[AAAA].● The remote control is necessary to operate [LAN datacloning].■ Data that can be copiedSettings and set values of [Picture], [Sound], [Setup] and[Position] menusUser image registered in [Setup] - [Image settings]The following contents of the [Detailed set up] page onthe Web control screen[Status notification set up]● The following data cannot be copied. Setting isrequired for each display.[Cloning password][Date and time][Network settings] - [Display name]Setting for [Network settings] - [LAN setup][Synchronize display setting][Time zone][NTP synchronization]NTP server nameDNS server[Control settings] in [Display ID]The setting contents of the [Change password] pageon the Web control screenThe following contents of the [Detailed set up] pageon the Web control screen[Network config][Adjust clock][Command port set up]The setting contents of the [Crestron Connected]page on the Web control screen■ Supported device● Commercially available USB memory devices aresupported. (Those with security functions are notsupported.)● USB memory devices other than those formatted inFAT16 or FAT32 cannot be used.● Up to 32 GB of USB memory in size are supported.● Only single partition configuration is supported.Copying the display data to the USBmemory1 Insert the USB memory device to theUSB terminal on the bottom of thedisplay.USBmemoryUSB terminalNote● Depending on the type of a USB memory device,it may come in contact with the periphery such asa back cover, and cannot be attached. Use a USBmemory device connectable to this unit.● Failure to save in or read from the USB memorydevice displays an error message.2 After the [Cloning password] screenis displayed, go to the step 6.When the [Cloning password] screen is notdisplayed, follow the steps 3 to 5 to display.3 Display [Setup] menu pressing.4 Select [Options] with and press.The following display appears.OptionsDisplay informationSoftware licensesCloning passwordUSB data cloningShippingLAN data cloningOutput log data5 Select [USB data cloning] withand press .[Cloning password] screen is displayed.6 Enter the cloning password, and thenpress .Data cloning screen is displayed.