Panasonic TH-98SQ1W Operating Instructions Manual

Also see for TH-86SQ1W: Operating instructions Operating instructions Operating Instructions - Basic Guide Operating instructions Operating instructions

Contents

Panasonic TH-98SQ1W Operating Instructions Manual Manual pdf 72 page image

72EnglishNetwork settingsSet when networking with a computer.[Network settings] submenu will be displayed.Network settingsSerial controlSQ1-000OffSERIAL INOffOffDisplay nameDIGITAL LINK statusDIGITAL LINK menuNetwork statusLAN setupAMX D. D.Extron XTPCrestron Connected ™ResetOffAuto display namePermitUSB memory network settingsDIGITAL LINK mode AutoNetwork control OffProtocol 2LAN control protocolDIGITAL LINK(Ethernet control) Enable■ [Serial control]Selects the RS232-C control terminal.[SERIAL IN]:Controls using the SERIAL IN terminal of thedisplay.[DIGITAL LINK]:Controls via the optional device that supportsDIGITAL LINK output (ET-YFB100G, ET-YFB200G) and the DIGITAL LINK / LAN terminal.[SLOT]:Controls via the function board inserted to theSLOT of this unit.■ [Network control]Set when controlling with the unit’s LAN terminal.[On]:Controls via LAN using the LAN terminal. Thepower indicator lights orange when the power isturned off with the remote control (standby).[Off]:Invalidates control with LAN terminal.(In this case, the power consumption of Standbycondition (when the power is turned off with theremote control) will be slightly reduced.)Note● When using the LAN control function which isdescribed in “Using Network Function” (see page84 ‒ 100), set this function to [On].● Even if the setting is set to [Off], the Web browsercontrol screens that do not control this unit (displayinformation [Status], detailed settings [Detailed setup] and password change [Change password])operate.■ [Auto display name]Sets whether to change the display name automatically.[On]:Changes the display name automatically inaccordance with the set point of the display ID.[Off]:The display name is not changed automatically.■ [Display name]The name of the Display that is shown on the networkcan be changed.Note● The name can be changed only when [Auto displayname] is set to [Off].● Display ID is not reset to default with [Networksettings] - [Reset].■ [LAN setup]Detailed network settings for the LAN can be configured.Select [LAN setup] with and press .192.168. 0. 8255.255.255. 0192.168. 0. 1102412:34:56:78:9A:BCLAN setupSaveDHCP OffIP addressSubnet maskGatewayCommand portMAC address[DHCP], [IP address], [Subnet mask], [Gateway]Press to set [On] / [Off] of [DHCP].When [Off] is selected, IP address and other settingscan be set manually.[DHCP]:(DHCP client function)[On]:Obtains an IP address automatically when a DHCPserver exists in the network the Display is going tobe connected.[Off]:When a DHCP server does not exist in the networkthe Display is going to be connected, set [IPaddress], [Subnet mask] and [Gateway] manually.[IP address]:(IP address display and setting)Enter an IP address when DHCP server is notused.[Subnet mask]:(Subnet mask display and setting)Enter a Subnet mask when DHCP server is notused.[Gateway]:(Gateway address display and setting)Enter a gateway address when DHCP server isnot used.