Panasonic TH-98SQ1W Operating Instructions Manual

Also see for TH-86SQ1W: Operating instructions Operating instructions Operating Instructions - Basic Guide Operating instructions Operating instructions

Contents

Panasonic TH-98SQ1W Operating Instructions Manual Manual pdf 62 page image

62English■ [Current input]Displays whether the input currently in use for viewingis the (main) input set by switching input or thebackup one.Setting conditionsThe following table describes restrictions (availablecombinations) on each setting item.MainHDMI1HDMI2DisplayPortDIGITAL LINKDVI-DSLOTPC USBBackupHDMI1HDMI2DisplayPortDIGITAL LINKDVI-DSLOT○ ○ ○PC ×USB ○ ○ ×○: Selectable for both Primary and Secondary.: Selectable for either Primary or Secondary.×: Not selectable for neither Primary nor Secondary.Recall displayPressing displays any of the followings.● When the main input is being used for viewing andthe operating conditions for the Backup Input functionare met.HDMI1FullBackup mode OK● When the backup input, enabled by the operation ofthe Backup Input function, is being used for viewing.HDMI1FullPrimary backup inputWhen the conditions for the Backup Input functionare met, the following screen is displayed.Backup mode OKNote● This menu will be greyed out and cannot be set underthe following conditions.• [Input search] is set to the item other than [Off].(see page 58)• [Setup] - [Image settings] - [No signal imagesettings] - [Display setting] is set to [On]. (see page68)• [Power management mode] is set to [Inputdetection]. (see page 64)● When set to the USB input, the unit determines videosignals are interrupted by judging the USB memory isnot connected to the USB terminal.● This function may not operate correctly depending onthe image playback device.Screensaver(For preventing image retention)Do not display a still picture, especially in 4:3 mode, forany length of time.If the display must remain on, a Screensaver should beused.[Screensaver] - submenu screenScreensaverStart10:00Mode OffMONDAY2018/01/01Wobbling Off■ Screensaver settingsScreensaver operationWhen the Screensaver is operating, the following 5patterns are displayed full screen for 5 seconds each,and it will be repeated.Black → Dark grey → Grey → Light grey → White →Light grey → Grey → Dark greyTo start Screensaver nowSelect [On] in [Mode].Select [Start] and press .● The Screensaver will be activated.ScreensaverStart10:00Mode OnMONDAY2018/01/01Note● If the following buttons are pressed while thescreen saver is operating, the screen saver iscancelled.Remote control: Unit: <+ (Unit)> <- (Unit)>● When the display is turned off, the Screensaver willbe deactivated.To set interval of ScreensaverSelect [Interval] in [Mode].Set [Periodic time].● Press to change the time by 15 minutes.● In [ENGLISH(US)] OSD language, [Periodictime] is displayed as [SHOW DURATION].