23EnglishNote● Component video signal is supported with thisterminal (Mini D-sub 15P).Change the [Component/RGB-in select] setting inthe [Signal] menu to [Component] (when Componentsignal connection) or [RGB] (when RGB signalconnection). (see page 55)● Additional computer, cables and conversion adaptershown are not supplied with this set.● If the computer being connected is not DDC2B-compatible, you will need to make setting changes tothe computer at the time of connection.● Do not set the horizontal and vertical scanningfrequencies for PC signals which are above or belowthe specified frequency range.● For audio, the AUDIO IN 1 / AUDIO IN 2 terminal canbe used. (For [Audio input select] function, see page66.)Pin assignments and signal names for PC InputTerminal (Mini D-sub 15P)167839451015 14 13 12 112Pin No. Signal NameR (PR /CR )G (Y)B (PB/CB )NC (not connected)GND (Ground)GND (Ground)GND (Ground)GND (Ground)+5 V DCGND (Ground)NC (not connected)SDAHD/SYNCVDSCLDisplayPort IN / DisplayPort OUTterminal connectionDisplayPort cable (commercially available)PC with DisplayPort outputNote● For audio, it is also possible to use the AUDIO IN1 / AUDIO IN 2 terminal. (For [Audio input select]function, see page 66.)● Depending on the device to be connected, it may taketime for images to be displayed.● Please use DisplayPort 1.2 compliant cable.● Depending on the types of cable or mini connectoradaptor used, 4K picture may not be displayed.● In connecting with PC which uses early chipsetsor graphic cards compatible with DisplayPort, if theDisplayPort output of the PC is connected to this unit,malfunction of this unit or the PC may occur. In thatcase, turn the power of the unit or the PC off, andthen turn it on again.When inputting DisplayPort output to this unit, itis recommended to use the PC which the newestChipset and Graphics Cards are used.
