Panasonic TH-98SQ1W Operating Instructions Manual

Also see for TH-86SQ1W: Operating instructions Operating instructions Operating Instructions - Basic Guide Operating instructions Operating instructions

Contents

Panasonic TH-98SQ1W Operating Instructions Manual Manual pdf 81 page image

81EnglishInformation timingSet up the informing manner for no signal ortemperature rising.RS-232C controls:Warning or error message sent from the displayautomatically.LAN controls:Acquire the warning or error message from thedisplay.[Information timing] - submenu screenInformation timingNo signal warningNo signal warning timingTemperature warningNo signal errorNo signal error timingOn5minOn10minOn■ [No signal warning]When set to [On], the display sends out the no signalwarning.■ [No signal warning timing]Set up the detecting time for no signal warning.(Range: 01 ‒ 60, Interval: 1 minute)■ [No signal error]When set to [On], the display sends out the no signalerror.■ [No signal error timing]Set up the detecting time for no signal error.(Range: 01 ‒ 90, Interval: 1 minute)● The warning of [No signal warning] and the errorof [No signal error] are not sent when the no signalstate is detected through any of the followingfunctions:[No signal power off], [HDMI1 power management],[HDMI2 power management], [DisplayPortpower management], [DIGITAL LINK powermanagement], [DVI-D power management], [PCpower management] (see page 64)Setting Example:● If there is no signal when [PC IN] is input, [PCpower management] is activated first and theDisplay enters the standby mode.[No signal warning timing]: 5 minutes[No signal error timing]: 10 minutes[PC power management]: [On] (60 seconds)Note● The [No signal error timing] cannot be setshorter than [No signal warning timing].● Even when a USB memory is connected, ifthere is no playable file, the unit determines nosignal is present.■ [Temperature warning]When set to [On], the display sends out the warningmessage.SLOT settingsSet for SLOT.This menu is displayed only when a function board isinserted into the SLOT.[SLOT settings] - submenu screenSLOT settingsSLOT power link OffSLOT power onSLOT forced terminationSLOT informationSLOT standby On■ [SLOT information]Displays the information of the function board insertedto the SLOT.■ [SLOT power link]Links the power operation of the SLOT with the poweroperation of this unit.[Off]:Does not link.[On]:The power of the unit is turned off when the powerof the inserted function board is turned off duringSLOT input or enters the power save mode. Afterthat, when the power of the function board isturned on or returns from the power save mode,the power of the unit is turned on.■ [SLOT standby]Sets the power supply status for the SLOT when theunit is in standby mode.[Off]:The power is not supplied to the SLOT when thepower is turned off by the remote control, etc.[On]:The power is supplied to the SLOT when thepower is turned off by the remote control, etc.Note● When [SLOT standby] is set to [On], the powerindicator in standby mode lights orange (red/green).■ [SLOT power on]Starts up the power of the SLOT.■ [SLOT forced termination]Forcibly turns off the power of the SLOT. Use this onlywhen the power cannot be turned off manually due tothe problem of the operating system, etc.