27EnglishCommandCommand Parameter Control detailsPON None Power ONPOF None Power OFFAVL ＊＊＊ Volume 000 ‒ 100AMT 0 Audio MUTE OFF1 Audio MUTE ONIMSNone Input select (toggle)HM1 HDMI 1 input(HDMI1)HM2 HDMI 2 input(HDMI2)DP1 DisplayPort IN input(DisplayPort)DL1 DIGITAL LINK input(DIGITAL LINK)DV1 DVI-D IN input(DVI-D)SL1 SLOT input (SLOT)PC1 PC IN input (PC)UD1 USB input (USB)MV1“Memory viewer”input(MEMORY VIEWER)DAMNone Screen mode select(toggle)FULL FullNORM NormalNATV NativeHFIT H fitVFIT V fitZOOM Zoom1ZOM2 Zoom2Note● If multiple commands are transmitted, be sure to waitfor the response for the first command to come fromthis unit before sending the next command.● If an incorrect command is sent by mistake, this unitwill send an “ER401” command back to the computer.● When sending a command which does not requireparameter, a colon (:) is not needed.● Consult your local Panasonic dealer for detailinstructions on command usage.For more details, visit the following web site.https://panasonic.net/cns/prodisplays/IR IN / IR OUT terminal connectionConnect the stereo mini plug (M3) cable from the IROUT terminal of the first display to the IR IN terminal ofthe second display.The infrared signal of the first display is sent to thesecond display.In this case, the IR (infrared ray reception on the remotecontrol sensor) on the second display does not operate.Repeating the above connections enables the daisychain connection.Note● Connection cables are not supplied with this unit.● Daisy chain connection is possible only between thedisplays of the same series.Stereo mini plug (M3) cable (commercially available)First displaySecond displayThird display
