124English8 Select [Execute] with and press.SQ1-001SQ1-002SQ1-004SQ1-005SQ1-014SQ1-006SQ1-041SQ1-009192.168. 0. 1192.168. 0. 2192.168. 0. 4192.168. 0. 25192.168. 0. 31192.168. 0. 7192.168. 0.124192.168. 0.211LAN data cloningStatusExecuteDisplay name IP addressSelect displayOffWrite protectNote● Data cannot be copied to the display for which[Write protect] is set to [On]. Set this to [On] toprevent [LAN data cloning] from being performedmistakenly when data copy is not necessary.● Once [LAN data cloning] is performed, [Writeprotect] is set to [On].9 A confirmation window appears.Select [Execute] with and press.LAN data cloningAll data for the selected displays will be changed.Are you sure you want to execute?Execute ReturnData copy to the display starts.LAN data cloningCloning in progress, please wait.DO NOT unplug your Display!10 The exit screen appears.The green mark on the list shows the data has beencopied successfully. The red mark shows failure.If the red mark appears, check the LAN cableconnection or power status of the display of the copydestination.SQ1-001SQ1-002SQ1-004SQ1-005SQ1-014SQ1-006SQ1-041SQ1-009192.168. 0. 1192.168. 0. 2192.168. 0. 4192.168. 0. 25192.168. 0. 31192.168. 0. 7192.168. 0.124192.168. 0.211LAN data cloningStatusCloning finished.Display name IP addressIf the data copy has finished, the message appearson the display of the copy destination.Cloning finished. Please turn off the power.11 Switch the button> ( ) on the unit of the copydestination to ( ) to turn the poweroff.The copied content is applied to the display.● If the is locked,please disconnect the AC cord plug from the walloutlet.Note● If the data is copied with [POWER button lock] set to[On], this function operates after turning the poweroff, and the cannot beused to turn the power on. In this case, remove thepower plug, wait sufficient time, and then connect thepower plug again to turn the power on.Changing the cloning passwordChanges the cloning password requiredto use the cloning function.1 Insert the USB memory device to theUSB terminal on the bottom of thedisplay.The password input screen is displayed.2 Enter the current password, and press[Ok].3 Enter the new password, and press[Ok].4 Enter the new password again forconfirmation, and press [Ok].Note● The initial password in the factory default state is[AAAA].● Change the password periodically, and set one whichis difficult to guess.● For initialization method for the cloning password,consult the dealer where you purchased the product.
