22EnglishPin assignments and signal names for DVI-D Input/OutputPin No. Signal NameT.M.D.S. data 2 -T.M.D.S. data 2 +T.M.D.S. data 2 shieldDDC clockDDC dataT.M.D.S. data 1 -T.M.D.S. data 1 +T.M.D.S. data 1 shield+5 V DCGND (Ground)Hot plug detectT.M.D.S. data 0 -T.M.D.S. data 0 +T.M.D.S. data 0 shieldT.M.D.S. clock shieldT.M.D.S. clock +T.M.D.S. clock -PC IN terminal connectionConnect a cablewhich matchesthe audio outputterminal on thecomputer.(commerciallyavailable)(Female) (Male)Mini D-sub 15p cable (commercially available)Stereo mini plug (M3) cable (commercially available)PCThe type of computer signal that can be connected● With regard to the typical PC input signals thatare described in “Preset Signals” (see page 128),adjustment values such as for the standard picturepositions and sizes have already been stored in thisunit.(Computer signals which can be input are those witha horizontal scanning frequency of 30 to 110 kHz andvertical scanning frequency of 48 to 120 Hz.)● The display resolution is a maximum of 1 440 x1 080 dots when the aspect mode is set to [Normal],and 1 920 x 1 080 dots when the aspect mode isset to [Full]. If the display resolution exceeds thesemaximums, it may not be possible to show fine detailwith sufficient clarity.● If signals outside the range of supported frequenciesare input, normal images cannot be displayed. Notethat some images may not be correctly displayedeven if signals are within the range.● If the PC screen is not displayed, check if the imagesignal of the PC meets “Preset Signals” (see page128), and then change the settings. For power-savingpurpose, image output may be OFF on a notebookcomputer. In this case, it may be set to ON withfunction key operation etc. of the computer. (Refer tothe manual of the computer.)
