Panasonic TH-98SQ1W Operating Instructions Manual

Also see for TH-86SQ1W: Operating instructions Operating instructions Operating Instructions - Basic Guide Operating instructions Operating instructions

Contents

Panasonic TH-98SQ1W Operating Instructions Manual Manual pdf 64 page image

64EnglishPower management settingsSet each item to reduce power consumption.This function works only for the input terminal that iscurrently selected.[Power management settings] - submenu screenPower management settingsPower management modeNo signal power offHDMI1 power managementPC power managementDVI-D power managementPower saveCustomOffDisableOffOffOffHDMI2 power management OffExtended standby mode OffInput detectionChanging delay OffDisplayPort power management OffDIGITAL LINK power management Off1. Setting [Power management mode]1-1 [Power management mode]: [On]The following fixed values are set to the menu ofpower consumption reduction. Individual setting isnot available.[No signal power off]: [Enable][HDMI1 power management]: [On][HDMI2 power management]: [On][DisplayPort power management]: [On][DIGITAL LINK power management]: [On][DVI-D power management]: [On][PC power management]: [On][Power save]: [On]1-2 [Power management mode]: [Custom]The menu of the power consumption reductionis individually set. This setting is enabled when[Power management mode] is set to [Custom].1-3 [Power management mode]: [Inputdetection]Sets the power consumption reduction menuindividually.This is enabled when [Power management mode]is set to [Input detection]. This mode interlocksbetween the power management operation and theinput detection function for operation. When thismode detects the change from without-signal stateto with-signal state by monitoring input signals,the input signal detection function operates, andan input is automatically switched to the input.Also, if the current input signal disappears, it isautomatically switched to another input. If all theinput signals disappear, the power managementfunction operates, and automatically turns thepower off/on. This operation is performed betweenselected terminals.Note● Set the “Power management” function to [On] forterminals to operate this function.● [Extended standby mode] is set to [On], and greyedout.■ [No signal power off]When this is set to [Enable], the power supply of theunit goes off automatically (standby) when there is nooperation or sync signal for about 10 minutes.Note● When set to the USB input, the unit determines nosignal is present if the USB memory is not connectedto the USB terminal, or the connected USB memorydoes not contain any playable file.● This function operates regardless of the [On] / [Off]settings of [No signal image settings].● This function may not operate depending on the videooutput devices.■ [HDMI1 power management]When this function is set to [On], it operates underthe following conditions to turn the power on or offautomatically.When no pictures (sync signal) are detected for60 seconds or so at HDMI1 input:Power is turned off (standby); the power indicatorlights up orange.When pictures (sync signal) are subsequentlydetected at HDMI1 input:Power is turned on; the power indicator lights upgreen.Note● This function may not operate depending on the videooutput devices.■ [HDMI2 power management]When this function is set to [On], it operates underthe following conditions to turn the power on or offautomatically.When no pictures (sync signal) are detected for60 seconds or so at HDMI2 input:Power is turned off (standby); the power indicatorlights up orange.When pictures (sync signal) are subsequentlydetected at HDMI2 input:Power is turned on; the power indicator lights upgreen.Note● This function may not operate depending on the videooutput devices.