63Advanced GuideBasic Guide1 Camera Basics2 Auto Mode /Hybrid Auto Mode3 Other Shooting ModesTv, Av, and M Mode6 Playback Mode7 Wi-Fi Functions8 Set-Up Menu9 Accessories10 AppendixIndex4 P Mode5 Tv, Av, M, and C ModesBefore UseAuto Exposure Bracketing (AEB Shooting)Still Images MoviesThree consecutive images are captured at different exposure levels(standard exposure, underexposure, and then overexposure) eachtime you shoot. You can adjust the amount of underexposure andoverexposure (relative to standard exposure) from –2 to +2 stops in 1/3-stop increments.1 Access the setting screen.● Press the [ ] button, choose [AEB]on the [ 3] tab, and then press the [ ]button (= 32).2 Configure the settings.● Press the [ ][ ] buttons or turn the [ ]dial to adjust values.● To cancel the AEB function, follow steps1 – 2 to set the AEB correction value to 0.● AEB cannot be used when the flash is not set to [ ], Multi ShotNoise Reduction is on (= 80), or when continuous or bulbshooting is active.● If exposure compensation is already in use (= 61), the valuespecified for that function is treated as the standard exposurelevel for this function. In step 2, you can turn the exposurecompensation dial on the screen to adjust the correction.● To view the automatically determined ISO speed when you haveset the ISO speed to [AUTO], press the shutter button halfway.● Although choosing a lower ISO speed may reduce imagegraininess, there may be a greater risk of subject and camerashake in some shooting conditions.● Choosing a higher ISO speed will increase shutter speed, whichmay reduce subject and camera shake and increase the flashrange. However, shots may look grainy.● This can also be adjusted by going to [ISO speed] on the [ 3]tab of the menu (= 32) and selecting [ISO speed].● If you want to select speeds up to [H] (equivalent to ISO 25600),go to the menu (= 32), choose [C.Fn I:Exposure] from the[ 1] tab, and set [ISO expansion] to [1:On] (= 88).Adjusting ISO Auto SettingsStill Images MoviesYou can select the maximum ISO speed used when ISO speed is set to[AUTO].1 Access the setting screen.● Press the [ ] button, choose [ISOspeed] on the [ 3] tab, and then pressthe [ ] button (= 32).2 Configure the settings.● Choose [ISO Auto] and then choose anoption (= 32).
