Panasonic TH-98SQ1W Operating Instructions Manual

Also see for TH-86SQ1W: Operating instructions Operating instructions Operating Instructions - Basic Guide Operating instructions Operating instructions

Contents

Panasonic TH-98SQ1W Operating Instructions Manual Manual pdf 59 page image

59English■ [Input search]: [Custom][1st search input], [2nd search input]Set the input to search when [Custom] is selected.[HDMI1] / [HDMI2] / [DisplayPort] / [DIGITAL LINK]/ [DVI-D] / [SLOT] / [PC] / [USB] / [(None)]■ [Input search]: [Input detection]Input searchInput searchHDMI1DVI-DChanging delayHDMI2Input detectionOffOffOffOffPC OffDisplayPort OffDIGITAL LINK OffSets the input to monitor during [Input detection].[HDMI1] / [HDMI2] / [DisplayPort] / [DIGITAL LINK]/ [DVI-D] / [PC][On]: The input is monitored.[Off]: The input is not monitored.■ [Changing delay]Sets the delay time until the input is switched during[Input detection].[Off]: Switches the input if a signal is interruptedeven for a very short period.1 ‒ 10: Sets the delay time (sec.).Switches the input when the set time haselapsed after detecting no signal is present.However, if the detection period duringwhich no signal is present is shorter than theset delay time, the input is not switched.Note● [Input detection] is the function that automaticallyswitches the input as below by monitoring thepresence of signal for the set input.• If a video signal is input to the set input that isnot displayed (When the status has changedfrom signal absent to signal present.), the input isselected and switched.• If no signal is detected for the displayed input, thesetting switches to the set input to which a signal isinput. Also, if no signal is present for the displayedinput when the power is turned on or when theinput is switched, the setting switches to the setinput to which a signal is input. When signals areinput to multiple set inputs, the priority order asdefault (immediately after power-on) is as follows:HDMI1, HDMI2, DisplayPort, DIGITAL LINK,DVI-D, PC.In the other case (When the input is switched afterpower-on), the input displayed last takes priority.● [Changing delay] is the function to prevent theaccidental input switch during a short period, such aswhen the signal is interrupted due to the frequencychange for the input signal while [Input detection] isoperating.If a signal is detected again within the set period(sec.), the input is not switched.● [Input detection] may not operate correctly dependingon the image playback device.Note● When set to the USB input, the unit determines nosignal is present if the USB memory is not connectedto the USB terminal.In addition, even when a USB memory is connected,if there is no playable file, the unit determines nosignal is present.● This menu will be greyed out and cannot be set underthe following conditions.• [Failover/Failback] is set to the item other than[Off]. (see page 60)• [Power management mode] is set to [Inputdetection]. (see page 64)• [Input lock] is not set to [Off]. (see page 69)• When [Setup] - [Image settings] - [No signal imagesettings] - [Display setting] is set to [On]. (see page68)● If the input is changed by this function, the last inputis selected when the power is turned on next time.If you wish to retain the original input when the poweris turned on, set [Initial input] to the original input.(see page 57)