133EnglishSymptoms Check[Controller ID function] function cannotbe used.(When using ID remote controller)Check whether [Controller ID function] is set to [On], or switchis set to . (see page 80)(When [Controller ID function] is set to [On], you need to set switch to and set the ID number.)The top or bottom of the picture on thescreen is cut off.The image position has been adjusted in the [Position] menu.Adjust the position of the picture on the screen.(see page 42, 43)There are areas at the top and bottomof the screen where picture is notdisplayed.When using a video software program (such as a cinema size program)with a screen wider than one in the 16:9 mode, blank areas separate fromthe images are formed at the top and bottom of the screen.Parts of the unit become hot.Even when the temperature of parts of the front, top and rear panels hasrisen, these temperature rises will not pose any problems in terms ofperformance or quality.There is no picture displayed or soundoutput sometimes.When HDMI or DVI signals are input to the Display using a selector ordistributor, sound or images may not be output in the normal fashiondepending on the selector or distributor used.The symptoms may be improved by turning the power off and on again, orby replacing the selector or distributor.The RS-232C is uncontrollable. Check whether the connection has been made properly. (see page 26)The LAN is uncontrollable.Check that the connection has been made properly.(see page 84)To control with WEB browser control or command control, check that[Network settings] - [Network control] is set to [On].(see page 72)Check that [LAN setup] is set properly.(see page 72)When connecting to a device of AMX, Extron or Crestron Electronics, Inc.,set [AMX D. D.], [Extron XTP] or [Crestron Connected™] according to thedevice to use.(see page 74)See the [DIGITAL LINK status] - [Signal quality] information to check theLAN cable status such as whether the LAN cable is disconnected or thecable is not shielded.(see page 74)There is no picture displayed orsound output from the [DIGITAL LINK]terminal.Check whether the connection has been made properly between the video(output) equipment and twisted pair cable transmitter and between thetwisted pair cable transmitter and this product.(see page 85)Check that [Network settings] - [DIGITAL LINK mode] is not set to[Ethernet].(see page 73)The file can be played back with “USBmedia player”, but not with “Memoryviewer”Check the playback file specifications of “USB media player” (see page103) and “Memory viewer” (see page 114).
