7.4 REMOTE PROGRAMMING (KX-TVS325 Only)Installation Manual 2337.4 REMOTE PROGRAMMING (KX-TVS325Only)There are 2 methods available for VPS programming:• Method 1—On-Site Programming Using RS-232CConnect the programming terminal with a serial cable with an RS-232C connector to theVPS (see 2.8 TERMINAL CONNECTION).• Method 2—Remote ProgrammingYou can perform programming and maintenance from a remote location by accessing theinternal modem card.This section provides important information about Remote Programming.Below is an example of the display that will appear when you access the VPS from a remotelocation.Screen output:If the access to the internal modem of the VPS is successfully established, the display willshow "Terminal Connected" as in the example above.The maximum data transfer rate of the internal modem is 33600 bps.When you access from a remote location, keep in mind the following:1. You cannot perform the On-Site Programming and Remote Programming at thesame time.If you try to establish remote access while On-Site Programming is in progress, theaccess will be denied and the display will show "Another Terminal Connected".To establish remote access, the screen for the System Administrator using the RS-232Cconnection must be as below:Likewise, access via RS-232C will be denied while remote access is established; thedisplay will show the same message, "Another Terminal Connected".Atdt91234567CONNECT 33600/LAPM/NONETerminal ConnectedEnter the Administrator Password :=Please Select Your Terminal Type.1. ASCII TERMINAL2. VT100Please Enter the Number :=>
