4.5 DPT INTEGRATION FEATURES AND SETUP PROCEDURES FOR THE PANASONIC KX-TA1232 AND KX-TDInstallation Manual 1394.5.10 Two-Way Transfer Button Assignment via StationProgrammingFor the Two-Way Transfer feature to work at an extension, the extension must have a TWTbutton on it. This key must either be a DSS/BLF or CO key with a lamp. Follow the procedurebelow to assign a TWT button on an extension. (This is a station level program and should bedone at each individual telephone.)PC programming is also available for KX-TD500 users (see 4.5.12 Button Assignment via PCProgramming).1. Enter PITS Programming:a. With the phone on-hook, Press the PROGRAM button.b. Dial [99]. (Display changes to PT-PGM Mode.)2. Press the desired FLEXIBLE (CO or DSS/BLF) button that you want to assign as theTWT button.3. Dial [91].Screen output: 2Way-Trans:4. Dial the Voice Mail extension number.Screen output: 2Way-Trans: _ _ _(_ _ _ = The extension number you entered).5. Press STORE.6. To exit the Station Programming mode, Press the PROGRAM button or lift the handset.7. Repeat these steps for each telephone.4.5.11 Voice Mail Transfer Button Assignment via StationProgrammingThis feature allows an extension user to transfer calls directly to a Voice Mailbox. This isavailable with both DPT and Inband Integrations.PC programming is also available for KX-TD500 users (see 4.5.12 Button Assignment via PCProgramming).1. Enter PITS Programming:a. With the phone on-hook, Press the PROGRAM button.b. Dial [99]. (Display changes to PT-PGM Mode.)2. Press the desired Flexible (CO or DSS/BLF) button that you want to assign as the VTRbutton.3. Dial [8].Screen output: VTR4. Dial the Voice Mail extension number.Screen output: VTR- _ _ _(_ _ _ = The extension number you entered).Conditions: This button must be a CO or DSS/BLF key to beprogrammed as a TWT button. When all Voice Mailports are busy and this key is pressed, the user willhear reorder tone.
