7.2 UTILITY COMMANDS218 Installation Manual7.2.18 Circuit Condition Display (LMON)Use the LMON command to display the circuit condition every 1.5 s. To turn off this command,enter [\].The following circuit conditions may be displayed.NoteThe maximum number of ports depends on the VPS model.7.2.19 Touchtone Information Display (PUTD)Use the PUTD command to display the touchtones the VPS receives and sends.In addition to the touchtones, the following will be displayed—the Incoming Call Service (VoiceMail, Automated Attendant, Custom, and Interview) entered by the caller and the time periodsthat the ports are enabled.Type PUTD. The VPS will remain in this mode until "PUTD" is entered again. The defaultsetting of this mode for all ports is "OFF".To change the mode from "PUTD" to "OFF", Type PUTD again."Ready" : Possible to serve"Incoming Call" : Processing arrival service"Outgoing Call" : Processing sending service"DSP Reset" : Processing DSP reset disposition"PT connect" : Processing PT connect disposition"Error" : DSP Card is not loaded$ LMONNo.:1: Ready2: Ready3: Ready4: Ready5: Ready6: Ready7: Ready8: Ready9: Ready10: Ready11: Ready12: ReadyStatus No.:13: Error14: Error15: Error16: Error17: Error18: Error19: Error20: Error21: Error22: Error23: Error24: ErrorStatus$ PUTDTarget Port : * * * * * * * * * * * * * * * * * * * * * * * *Don't leave enabled after troubleshooting.$
