5.1 STARTING UPInstallation Manual 157Depending on your PBX type, some steps will be skipped as shown below.* Not available in the United States.5.1.3 Starting the Quick SetupThe sequence must be followed through to the end to take effect. If you press "\", you will haveto start over. Quick setup may be performed again without erasing prior data.Notes• The screen samples given in this section are for the KX-TVS325; if your VPS modelis the KX-TVS125 or KX-TVS225, some of the screens may look different.• Depending on PBX extension numbering, the mailbox numbers might be 2- to 5-digitlong.At the System Administration Top Menu, Type [5] and Press ENTER, or Type [3] then QSETand Press ENTER. See 7.2.17 Quick Setup (QSET) for more information.Screen output:Table 5-1PBX Type Required ProceduresKX-T308/T616 1 2 3 4 5 6 7 8KX-T1232/TA624/T336/T96* 1 3 4 5 6 7 8Non-Panasonic System 1 3 4 5 6 7 8KX-TD816/TD1232/TA1232/TD500/TD308/TDAseries/TAW series 1 4 5 6 8Quick Setup Utility for connection to Panasonic KX-T series telephone systemsThis utility provides a quick way of programming the Voice Processing System to operatein a standard automated attendant or voice mail configuration when connected to aPanasonic KX-T series telephone system. The system will prompt you to enter, modify orconfirm settings based upon which PBX type you select.By entering the appropriate information in the following screens, the system sets PBXintegration parameters, identifies the extension numbers connected to it, creates defaultmailboxes, sets its ports to handle callers with automated attendant or voice mail service,sets system passwords and sets the time and date. Finally, it confirms if you want toactivate the system based on the information you entered, modified or confirmed.To proceed, press Enter. To exit and cancel Quick Setup now, press \ .System Administration Top MenuorSystem Administration Top Menu53 QSET
