4.6 DPT INTEGRATION FEATURES AND SETUP PROCEDURES FOR THE PANASONIC KX-TDA/KX-TAW152 Installation Manual4.6.11 Voice Mail Transfer (VTR) Button AssignmentFor the Voice Mail Transfer feature to work at an extension, the extension must have the VTRbutton. This button must either be a DSS/BLF or CO button with a lamp. Follow the procedurebelow to assign a VTR button on an extension. (This is station level programming and shouldbe done at each individual phone.) PC programming is also available (see 4.6.12 ButtonAssignment via PC Programming).1. Enter Station (Personal) Programming:With the phone on-hook, Press the PROGRAM button.(Display changes to PT-PGM Mode.)2. Press the desired Flexible (CO or DSS/BLF) button that you want to assign as the VTRbutton.3. Press [94].Screen output: VTR-4. Enter a Voice Mail floating extension number.Screen output: VTR- _ _ _(_ _ _ = The Voice Mail floating extension number you entered).5. Press STORE.6. Press the PROGRAM button or lift the handset to exit the Station (Personal)Programming mode.7. Repeat these steps for each telephone.4.6.12 Button Assignment via PC ProgrammingThe KX-TDA/KX-TAW series users can assign buttons for Two-Way Recording (TWR), Two-Way Transfer (TWT), and Voice Mail Transfer (VTR) via PC Programming. Follow theprocedure below to assign each button.1. Go to "4.Extension-1.Wired Extension-4.Flexible Key" screen.Conditions: This button must be a flexible (CO or DSS/BLF)button to be programmed as a VTR button. When allVoice Mail ports are busy and this key is pressed, theuser will hear reorder tone.
