B6 SYSTEM ADMINISTRATION—SYSTEM PARAMETER SETTINGSInstallation Manual 333MessageManagerAccessfromTelephone1: Disable2: Enable(Disable)Enables/disables access to the VPS from the MessageManager’s telephone.NoteThe System Administrator will be asked to set aMessage Manager password if both of the followingconditions are met:• The System Administrator changes thisparameter from "Disable" to "Enable".• The Message Manager password has not beenset previously.The password must be entered twice for verification.DefaultPasswordforSubscriber1: No2: Yes(No)Defines whether or not the VPS sets a default password toSubscribers’ Mailboxes when they are created. The defaultpassword depends on the setting in the following "DefaultPassword Format" parameter.NoteEven if this parameter is changed from "No" to "Yes", anew default password will not be set to already-createdmailboxes. Pre-assigned passwords remain valid.The password can be changed in the following ways:• Subscribers can change or clear the defaultpassword for their mailboxes within SubscriberService.• The System Administrator or the System Managercan reset the password.After the password is reset, the conditions will beas follows:’ Mailboxes>If this parameter is set to "Yes", the password willbe initialized to the default password. If thisparameter is set to "No", the password will becleared.’ Mailboxes>The password is initialized to "No password".When the System Manager’s password is reset,the "System Manager Access from Telephone"parameter will automatically change to "Disable".When the Message Manager’s password is reset,the "Message Manager Access from Telephone"parameter will automatically change to "Disable".Table B-30Parameter Value Range(Default)Description/Function
