B5 SYSTEM ADMINISTRATION—SERVICE SETTINGSInstallation Manual 305Operator’s Parameters-Day Mode-Operator 1Use this parameter to enable or disable the Operator Service. It specifies Operator 1’sextension and the treatment of the calls transferred to that extension. The extension numberassigned for Operator 1 in the Day Mode will be for the Message Manager. When Operatorservice is enabled, operator-seeking calls first reach Operator 1’s extension.Notes• Because the extension number assigned for Operator 1 in the Day Mode is for theMessage Manager, you cannot assign this extension to any other mailbox.• By default, the extension number for the Message Manager’s extension (assigned forOperator 1 in the Day Mode) is "0". However, the default setting cannot be used withthe Message Waiting Notification—Lamp feature and the Remote Call ForwardingSet feature. When using these features, You must assign the extension number thatis included in the Extension Numbering Plan.To access the menu for Operator Parameters-Day Mode-Operator 1, follow themenu path as shown:System Administration Top Menu-1-4-1-2-1-1Table B-12Parameter Value Range(Default)Description/FunctionOperatorService1. Disable2. Enable(Enable)Enables or disables the Operator Service feature.NoteAll non-touchtone input calls in AutomatedAttendant Service will be transferred to the GeneralDelivery Mailbox when the Operator Service isdisabled.Operator’sExtension1-5 digits(0)Specifies the extension number for Operator 1.Notes• The default setting (0) cannot be used with theMessage Waiting Notification—Lamp feature.An extension number must be assigned that isincluded in the Extension Numbering Plan.• The extension number must not be assignedanywhere else (in particular, the extension mustnot have a mailbox). Otherwise, you will get anerror message.Operator’sMailbox No.2-5 digits(KX-TVS125/KX-TVS225: 998; KX-TVS325: 9998)Callers to Operator 1 are prompted to leave a messagein this mailbox depending upon how the Busy Coverageor No Answer Coverage modes are set.
