4.1 GUIDELINES FOR DPT INTEGRATIONInstallation Manual 103NoteDepending on the model and/or the software version of the connected PBX (see 3.1.1DPT or Inband Signaling?), you may not be able to utilize some of the features listedabove. For more information, call National Parts Center at 1-800-833-9626.Caller Name Announcement(System/Personal)* 1The VPS announces the prerecorded Caller IDcallers’ names when: (1) extension users listen tomessages from assigned numbers left in theirmailboxes, (2) the VPS transfers calls from assignednumbers to the users, and (3) the VPS pages theusers by intercom.If the same Caller ID number is programmed for bothsystem and personal caller name announcements,the VPS will use the personal caller name.Caller ID Call Routing* 1 The VPS automatically sends calls from pre-assignedCaller ID numbers to the specified extension, mailboxor Custom Service.DID Call Routing*2 The VPS automatically sends calls from pre-assignedDID numbers to the specified extension, mailbox orCustom Service.Personal Greeting for CallerID*1Each subscriber can record up to 4 personal greetingmessages for special callers.Time Synchronization Whenever the PBX sets a new date and time or whenDPT Integration is established, the data isautomatically registered in the VPS.Toll Saver*2 Subscribers can check their mailboxes from pre-assigned Caller ID numbers or by dialing a pre-assigned DID number without telephone charges.*1 When an incoming outside call reaches the VPS via the PBX, the VPS willwait about 2 rings before answering the call to receive the Caller IDinformation properly from the PBX.This waiting time can be changed by using the WCID command (see 7.2.20Wait for Caller ID (WCID) in 7.2 UTILITY COMMANDS).*2 DID Call Routing and Toll Saver using DID numbers are only available whenthe VPS is connected to the following PBXs with DPT Integration.• KX-TD816 (P311Q or higher)• KX-TD1232 (P211Q or higher)• KX-TD500 (V4M or higher)Table 4-1 DPT INTEGRATION FEATURES
